Single Section Plane

[[Je...]]

Dear Froum, 

I used a single section plabe on my mesh. But I only can find the option to move the plane on one axis. Also I cant rotate the place. So choosing an angle of degree. Is there any better tutorial to this? So far the GOm tutorial doesnt show it. 

Kind regards 

Jennifer 

 

[[Be...]]

Hi,

you have to construct a rotated plane or a rotated coordinate system to use this plane as input for a section creation. During the section creation you can only add an offset in negative or positive normal direction of the specified plane.

Hope this helps?

Regards,

Bernd Alpers