Jump to content

Datum system error


---
 Share

Recommended Posts

Hello,

I want to create a datum system by activating MMC.
However, I am getting the error in the picture below.
Can you help with this problem?
image.png.8a12a5bb2074e6f993e0903633b237c8.png

image.thumb.png.5b443cd710380a1c4b6941e3aae9e899.png

Link to comment
Share on other sites

Hello Latif,

it does not work for the reason stated in the dialog: the maximum virtual condition is violated (checks "S" on both circles). 

Regards,
Nanno 

Link to comment
Share on other sites

to aid the translation of this ..the datum fails at step 1 .  if the element that it is based on fails then the datum cannot be created . 

the only way to get around the error is to increase the tolerance of the size to allow the mathematics to work .   but of course you would need to understand the implication of doing so .

Link to comment
Share on other sites

The intended behavior if you have a datum system under material requirement with violated material condition is:

1) Creation of the datum system should be possible

2) Datum System remains uncomputed and delivers the displayed error.

I assume the screenshot with disabled OK button is taken from the edit creation of the datum system.

Please have a look into our tech guide, there is a page describing the technical backgrounds for datum system under material requirement: https://techguide.gom.com/en/gom-software-2021/article/general_mmr_background_information.html

 

Hope this helps

Christoph Schult

Link to comment
Share on other sites

 Share

×
×
  • Create New...