[Iv...] Posted November 18, 2020 Share Posted November 18, 2020 +++Repost from old forum+++ Hi, How do you perform calibration using the software? I cannot seem to find any information regarding how to upload calibration images into the program. Thanks. Link to comment Share on other sites More sharing options...
[Iv...] Posted November 18, 2020 Author Share Posted November 18, 2020 it is not possible to calibrate in the correlate software. The calibration should be performed in the ARAMIS software even before starting the stage acquisition. You can only define a scale in correlate within a 2D Project. Greetings Ivan Link to comment Share on other sites More sharing options...
[ya...] Posted August 19, 2021 Share Posted August 19, 2021 Please sign in to view this quote. Ivan, Is it possible define scale of two axises ? I mean define the length as well as the width? and if its possible so how? In the instructional videos the width axis is always defined only, but the Strain in the y axis base on the defenition of the length as well. Link to comment Share on other sites More sharing options...
[Iv...] Posted August 19, 2021 Author Share Posted August 19, 2021 Hi Yarden, no it's not possible to use two axes. The image is only 2D and what you do is define a scale. In other words how many pixel are a defined length. This linear behavior is used throughout the whole project and image. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in