Why does 'Check Position' lack the the UZ option?

[[Er...]]

GOM has implemented UZ (tolerance offset) for profiles, why not for positions?

This would be very useful, since asymmetric tolerances are very common for planes.

See below picture from ISO 1101 : 2017, Clause 8.2.2.1.3, page 19:

[[Ch...]]

Hi,

UZ option on position tolerances will be introduced with the GOM Software 2021 available this summer.

 

 

Best regards

Christoph Schult

 

[[Er...]]

Hi Christoph,

That's very good news! Thank you for your reply.