Jump to content

Recommended Posts

Hi every body,

I want to know is it possible to get the strain rate from 2-D digital image correlation in this software?

thanks in advance

Link to post
Share on other sites

Just an additional comment:

If the measurement was done with GOM Snap 2D or another GOM System or you import a movie/video file, the time delta of your stages (Ivan mentioned) should already be set.

If you import an image series, the time delta of your stages is set to 1s by default. It can be adapted by "RMB on the time line -> Manage Stages -> Select all stages in the pop up dialog -> Edit Time Stamp".
image.png.5123cbc6db4ac2e4393271d753644bae.png

The strain rates are available as "Inter-Stage Checks" in I-Inspect:
image.png.1895d42e83d43a6abc25592adef28b7f.png

Link to post
Share on other sites
×
×
  • Create New...