Create routine to measure Ø

[[Nu...]]

Hello all,

I need to check a dimension that are inscribed on draw as Ø, but the only way that i have to check it is by measure a point on surface and ask de polar coordinate to that point based on center.

After that i have to multiply by 2 in order to achive the Ø. Its possible create one routine that multiply the measured value and give me the correct value (Ø)?

 

Thanks

[[Be...]]

Hi,

have you created a circle, cylinder or sphere? If yes, then you can create easily a diameter check on these elements via the I-Inspect.

If not can you clarify your problem with some more images of the GOM software and your project and your created elements?

Regards,

Bernd