Jump to content

Touch Probe Question


---
 Share

Recommended Posts

Good day,

I have found when probing surfaces with the touch probe, the point data is 2.5 mm away from the actual scanned surface with is incorrect.  My probe is 2.5 mm radius, so it seems like there may be a link there.

Does ATOS have a compensation correction for the probe diameter?  Where can I find / adjust this?  I made sure to type in the radius correctly upon calibration.

We are using GOM Inspect Pro with a freshly calibrated touch probe.

Thank you,

Adam

Link to comment
Share on other sites

 Share

×
×
  • Create New...