Can I flip the direction of the vector arrows that show deviation on Position?

[[Ky...]]

I am doing some simple position measurement on some holes on a die cast part. However, when I click to show vectors, they point in the direction towards where the hole should be and not in the direction of the direction the hole is moving from nominal? Is there a way to change this? All of our CMM report outs, that everyone is used to seeing, shows the arrows in the direction of movement, not direction towards nominal.

[[Ma...]]

Same request here.
 

 

[[Tr...]]

Following this topic too. Vectors is a great feature but is not intuitive when the direction is pointing from actual to nominal. 

[[Be...]]

Hi,

unfortunately there is no possibility to change the current direction, but I added your wish to our internal ticket. I can't promise if or when we would implement a solution to this wish.

Regards,

Bernd

Edited March 5