LINEAR DEVIATION FLYOUTS SIGN

[[Li...]]

Hello, I would like to make a change to the display of the results in the linear deviations flyouts as shown in the screenshot below.

I want to correlate them with the triad because currently, I seem unable to do so. Each linear deviation in the screenshot displays a positive sign, but I want the flyout to indicate to the viewer the actual direction of the deviation relative to the XYZ triad.

Currently, I can only obtain flyouts with a positive (+) sign in front of the deviation, as if it were an absolute measurement. Instead, I want the flyout to indicate the actual sign relative to the triad. If the measured point is offset negatively relative to the nominal coordinates of the CAD, I want the flyout to reflect this.

I've tried to adjust the settings of the software, but to no avail. Could somebody please help me out?

Thank you very much!