Jump to content

Export Label Geometry Information


---
 Share

Recommended Posts

---

I am inspecting airfoil leading edge sections using the Profile Edge Ellipse command.  For the constructed ellipses I would like to export the geometry information in the labels - specifically the major and minor diameter.  Is there a method for doing this?

image.thumb.png.8d982d51879999aff016de4dcbd98596.png

 

Thank you in advance,

 

Jon Bittner

Link to comment
Share on other sites

---

Hey Jon,

If you perform the desired checks, you can export them from the table (e.g. as csv).

image.png.92b86565ff4289930cc0042ff8dd70f3.png

I hope this helps, if not just let me know.

Jens

Link to comment
Share on other sites

---

Thank you - I was not aware that "check ellipse" was available.  I haven't used ellipses before and "check ellipses" was not listed in the direct help topics.

Link to comment
Share on other sites

 Share

×
×
  • Create New...